This week I've been looking at the rear drivers side wing. I already knew about a small hole at the top of the wheel arch but there was a ton of filler over most of the wing as well. It all looked in reasonable condition apart from at the bottom of the wing just behind the drivers door. The filler was just starting to lift a bit so I thought I'd better take it back to the metal to clean it up. Unfortunately there turned out to be not a lot of metal! As can be seen from the pictures, filler had been applied over a large hole running the length of the wing from the door to the wheel arch. So it looks like I'm now going to have to brush up on my welding skills to fit a repair panel
